Faults And Repairs; Replacing The Oven Light Bulb; After-Sales Service - CONSTRUCTA CH210253 Gebrauchsanleitung

Faults and repairs

In the event of a fault, check the tips in the following table
before calling the after-sales service.
Problem
Electrical operation is faulty (e.g. indicator
lamps no longer light up)
Liquid or runny dough runs to one side
Smoke is generated during roasting or
grilling
High levels of condensation are generated
in the cooking compartment
Enamelled accessories have matt, light-
coloured marks
Door panels are misted up

Replacing the oven light bulb

Replace faulty oven light bulbs.
You can obtain replacement light bulbs from customer service
or specialist retailers: E14, 220 - 240 V, 40 W, heat resistant to
300 °C. Only use these oven light bulbs.
:
Risk of electric shock !
Disconnect the appliance from the power supply. Switch off the
circuit breaker or remove the fuse from the household fuse box.
Place a tea towel in the cold cooking compartment to prevent
1.
damage.
Turn the glass cover anticlockwise and remove it.
2.
Replace the oven light bulb with a bulb of the same type.
3.
Screw on the glass cover again.
4.
Remove the tea towel and switch on the circuit breaker.
5.
Note: If the glass cover cannot be unscrewed: use rubber
gloves to turn it. You can order a special removal tool through
the after-sales service (order no. 613634)
Changing the door seal
If the door seal is defective, it must be replaced. Replacement
seals for your appliance can be obtained from the after-sales
service.
The door seal is attached in four places (figure A). When
replacing it, disconnect and attach the hooks at all four points
(figure B).
52
:
Work on the appliance electronics may only be performed by
■
a specialist.
Always disconnect the appliance from the power supply
■
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
Possible cause
Fuse defective
Appliance not installed level
Fat is burning on the grill element
Wire rack or universal pan inserted incor-
rectly
Normal occurrence (e.g. when baking
cakes with very moist toppings or roasting
a large joint)
Normal occurrence caused by dripping
meat or fruit juices
Normal occurrence caused by tempera-
ture differences
$
Check again to ensure that the seal is seated correctly in the
corners in particular.

After-sales service

In the event of faults and repairs that you cannot rectify yourself,
please use our after-sales service.
You can find the addresses in the after-sales service directory.
Note: You will be charged for calling the after-sales service
regarding an operating error.
When contacting the after-sales service, please specify the E-
number and FD number.
You can find these on the rating plate behind the appliance
door on the left-hand bottom edge.
E no.
Additional information on products, accessories, replacement
Produktinfo
parts and services can be found at www.constructa.de and in
the online shop www.constructa-eshop.com
Risk of electric shock!
Remedial action
Check fuses in the fuse box and replace if
necessary
Check the appliance installation (see the
Installation instructions)
Continue grilling or roasting until the fat on
the grill element is burnt away
Check the shelf heights (see section:
Roasting or grilling)
Open the appliance door briefly from time
to time during operation
Not possible
Heat the appliance up to 100 °C and then
switch off again after 5 minutes
%
FD no.