Getting To Know Your Appliance; The Hotplates; Hotplate And Residual Heat Indicators; Setting The Hob - CONSTRUCTA CH M 10 Serie Gebrauchs- Und Montageanleitung

Use the residual heat of the hob. For longer cooking times,
■
you can switch the hotplate off 5-10 minutes before the end
of the cooking time.

Getting to know your appliance

The instruction manual is the same for various different hobs.
An overview of the models with their dimensions is given on
page 2.

The hotplates

Hotplate Activating and deactivating
$ Single-circuit
hotplate
ð Dual-circuit To activate: turn the hotplate control clock-
hotplate wise to ð. Set the heat setting. To deacti-
vate: turn the hotplate control to 0 and
reset. Never turn the hotplate control
beyond the ð symbol to 0.
î Extended To activate: Turn the hotplate control clock-
cooking zone wise to æ. Set the heat setting. To deacti-
vate: turn the hotplate control to 0 and
reset. Never turn the hotplate control
beyond the æ symbol to 0.

Setting the hob

This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.

Switching the hob on and off

You can switch the hob on and off with the hotplate controls.

Table of cooking times

The following table provides some examples.
Cooking times and heat settings may vary depending on the
type of food, its weight and quality. Deviations are therefore
possible.
Melting
Butter, gelatine
Heating and keeping warm
Stew (e.g. lentil stew)
Milk**
* Ongoing cooking without lid
** Without lid

Hotplate and residual heat indicators

The hotplate and residual heat indicators " light up when a
hotplate is warm:
Hotplate indicator - during operation, shortly after you have
■
switched on a hotplate.
Residual heat indicator - after cooking, when the hotplate is
■
still warm.
You can use the residual heat to save energy, e.g. to keep a
small dish warm or to melt chocolate.

Setting a hotplate

Adjust the heat setting of the hotplates using the hotplate
controls.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
Note: Hotplate temperature is regulated by the heat switching
on and off.The heat may also switch on and off at the highest
setting.
This ensures e.g.:
sensitive components are protected from overheating
■
the appliance is protected from electrical overload
■
better cooking results are achieved
■
For bringing liquids to the boil, use heat setting 9.
Stir thick liquids occasionally.
Ongoing cooking
setting
1
1
1-2
Ongoing cooking
time in minutes
-
-
-
15