Pelgrim NF940 Anleitung Seite 42

Gasconnection: RC 1/2˝ (ISO 7/1-RC 1/2)
The gas connection must comply with
I
national and local regulations. Amongst
other things these regulations instruct that:
– only approved materials are to be used.
Connecting the gas can be done at the rear
side either at the top left or right-hand corner.
This can be done by swapping over the gas
connection and the cap.
Please note:
The type of gas and the country for which the
appliance has been designed are indicated on
the ratings plate. The appliance is set in the
factory for G25 (natural gas) with a pressure
of 25 mbar Appliance category 2 sub c
ategory 1.
I Connect the oven directly to the mains.
This is because the oven can reach high
temperatures. It can also be connected
with a specially designed gas hose.
Attach this hose at the side of the oven to
prevent it touching any hot parts. A gas
tap, which is easily accessible, should
always be used for the appliance.
Table :
G25/25mBar
Burner type
simmerburner
semi rapid burner
rapid burner
wok burner
Built-in dimensions
900
890
-
-
950
940
50
Fitting the adjustable feet
The oven is equipped with 4 adjustable feet that
can be used to adjust the height of the oven.
Lift the oven up and screw the feet into the
special openings in the corners (see fig. 16).
(kW)
1,00
1,75
3,00
3,60
600
900
fig. 15