Setting - Pelgrim CKT745 Anleitung

use
86

Setting

On the glass work surface the 4 cooking zones are indicated by a circle. The
diameter of the base of the pan should correspond as closely as possible with
the diameter of the cooking zone.
The ceramic hob is equipped with residual heat indication, (child) lock,
automatic limitation of cooking time.
The CKT755 and CKT770 are also equipped with one or more double-ring
cooking zones and a cooking timer,
On this page and the following ones, you can read how to use these facilities.
Switching on and off
Switching on
1. Put a pan on a cooking zone.
2. Press the on/off button.
A light above the on/off button comes on.
The hob is now in stand-by mode. You must now operate the hob within 5
seconds, otherwise the hob will switch itself off again (the light goes out).
During the cooking process the on/off button can be used as an emergency
switch-off. Press the button and the appliance will switch off immediately..
use
87
Setting the power level
The cooking zones have 9 settings.
1. Press the + button for the cooking zone concerned.
The cooking zone immediately sets itself to position 6. Or press the button
for the relevant cooking zone. The cooking zone will immediately set itself to
position 1. The cooking zone will now heat up. The cooking zone switches on
and off automatically to provide the power you have set. At lower settings
the cooking zone is off for a long time and on from time to time. At higher
settings the cooking zone is on for a long time and off from time to time.
2. Select a higher or lower setting by pressing the + or - key again. The display
will indicate the selected setting.
The table on pages 92 and 93 shows which settings you should select.
Switching off
Press the - button until the cooking zone is on setting 0. After 5 seconds this
will change to an H, referring to residual heat (see residual heat indication).
higher
lower