Installation Instructions For The Square; General Instructions - WANDERS Square 60 Anleitung

Installation Instructions for the Square

General instructions

Preparation
Installation
Connecting the stove
Repairs
General instructions
The Square is tested in accordance with the international
EN 13229 standardization, and has an extra additional
standardization for optimally environment-friendly
heating devices related to flue gases (Section 15a B-Vg.
Des BmfWA). The stove can be connected to a flue tube
to which several stoves are connected. The flue pipe has
a diameter of 150 millimetres.
The heating device must be placed by an acknowledged
installer and according to the installation instructions
given below. The national and local rules and regulations
for placing and using wood-burning stoves are equally
applicable. WANDERS does not give any guarantee if
the Square is connected or installed incompletely or
incorrectly.
It is not allowed to place the stove in:
dwellings.
are used.
mechanical exhaust system is placed, except when
the air supply is taken directly from outside to assure
a hazardless combustion.
Preparation
The chimney flue
Before placing the stove you must observe the following
points:
must first have the chimney professionally cleaned
and checked by a qualified chimney sweep company.
Any cut-off valves or stop valves must be removed.
chimney without diversions.
20
20
20
21
21
22
Pa or 0.12 mbar.
(see the drawing and the table below)
must be clean, leak-proof and without obstructions,
and must have a diameter of 150 mm.