Before Installation; Scope Of Delivery; Assemble Device; Connect Antenna Cable - AEG CTV 2402 Bedienungsanleitung

WARNING:
• Protect batteries from heat and direct sunlight. Do not dispose of batteries by burning, danger of explosion!
• Keep batteries away from children. They are no toys.
• Do not force batteries open.
• Avoid contact with metal objects (rings, mails, screws, etc.), risk of short circuit!
• Short-circuited batteries can heat up and even ignite, risk of burns.
• For your own safety cover battery terminals with sticky tape during transport.
• In case of battery leakage avoid contact with eyes and mucous membranes. After contact wash your hands, rinse
eyes with clear water and contact physician with persistent troubles.
CAUTION:
• Do not use odd battery types or fresh and exhausted batteries.
• Do not dispose of batteries with the household trash. Return exhausted batteries to collection points or your dealer.
NOTE:
• If the remote control range shortens the batteries are exhausted and must be replaced.
• Do not use rechargeable batteries.
• Protect batteries from heat and direct sunlight. Do not dispose of batteries by burning, danger of explosion!
• Remove exhausted batteries from the device. Remove the batteries during longer periods of non-use to avoid bat-
tery leakage.
• Wash thoroughly after coming into contact with battery acid.

4. Before Installation

4.1 Scope of Delivery

After unpacking ensure that the following parts were included:
• TV set
• Stand and four Phillips screws
• Mains cord
• Remote control (incl. 2 x 1.5V batteries type LR03 AAA)
• User manual

4.2 Assemble Device

• Attach the stand with the four Phillips screws.
CAUTION TIPPING HAZARD:
Use two lock bars under the stand to lock the joint to prevent
the TV set from tipping over. Slide the lock bars to LOCK posi-
tion (see Figure).
• Remove the protective film from remote control and TV set, if
attached.
• Place the TV set on a stable, level surface. Ensure that the surface
can carry the TV's weight.
• Protect the device from extreme heat and humidity.
• Ensure sufficient ventilation on all sides. When placed in a wall unit leave at least 20cm on top and 10cm distance at
the sides for ventilation.

4.3 Connect Antenna Cable

The TV set festures a tuner to receive TV signals via antenna/cable and DVB-T signals.
CAUTION:
• Connect the antenna cable before connecting to mains power supply.
• DVB-T reception: The device is intended for reception via passive DVB-T antenna.
• Connect the DVB-T antenna to ANT input.
• In the source menu (press SOURCE button) select DTV.
ENGLISH
55