Installation; Electrical Connection - Pelgrim CKV 600 Anleitung

Installation

Electrical connection

230 V - 50 Hz
Connection: 5800 W
The power supply to the hob is via the oven or
the separate control panel. You can read how
to connect the appliances to each other in the
installation instructions for these appliances.
Assembly
Fit a wooden plate to protect the hob if the
hob is combined with a control panel
(see fig. 4).
Please note:
Do not fit a hob next to a cupboard or wall
made of flammable material above the
worktop. (If there is no alternative then keep
to a minimum distance of 40 mm between the
outer edge of the hob and this wall.
min. 5
Keep a distance of at least 650 mm between
the hob and any extractor hood to be fitted.)
Mark out the cut out (560 x 490 mm) on the
worktop (see fig. 5).
580 511
560 490
Place the hob in the cut out and secure the
fixing brackets (see fig. 6).
30 mm
50 mm
After fitting the hob check that the
appliance operates correctly.
fig. 4
42
fig. 5
fig. 6