Overheating Guard; Cleaning, Maintenance And Ordering Of Spare Parts; Storage; Disposal And Recycling - EINHELL CH2000/1 Originalbetriebsanleitung

GB
Various heating phases can be programmed with the
timer switch. For automatic mode, set the correct time
of day by turning the scale in clockwise direction. The
arrow on the timer switch indicates the set time. The
switch-on time can be set by pulling out the
segments, the switch-off time by pushing in the
segments.
Each segment corresponds to a period of 15 minutes.
The set program will repeat itself every 24 hours.

7.5 Overheating guard

In case of excessive heating, the equipment shuts
down automatically. If this occurs, turn off the
equipment, disconnect the mains plug and wait a few
minutes for the appliance to cool. After eliminating
the cause (e.g. a covered air grille), the equipment
can be switched on again. If the overheating guard
triggers repeatedly, please contact ISC GmbH.
8. Cleaning, maintenance and ordering
of spare parts
8.1 Cleaning
Before carrying out any cleaning and
maintenance work the equipment must be turned
off, disconnected from the power supply and
cooled down.
Maintenance and repair work may only be
carried out by an authorized electrical servicing
contractor or ISC GmbH.
Check the mains lead at regular intervals for
signs of defects or damage. A damaged mains
lead may only be replaced by an electrician or
ISC GmbH in compliance with the relevant
regulations.
Use a slightly damp cloth to clean the casing.
Remove dust pollution with a vacuum cleaner.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts
Please provide the following information on all orders
for spare parts:
Model/type of the equipment
Article number of the equipment
ID number of the equipment
Part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info.
14

9. Storage

Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.

10. Disposal and recycling

The device is supplied in packaging to prevent its
being damaged in transit. This packaging is raw
material and can therefore be reused or can be
returned to the raw material system. The appliance
and its accessories are made of various types of
material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.