CME Toptel 5 Gebrauchsanleitung Seite 14

2. Press the LEARN key briefly and then, within five seconds,
press and hold down any key on the original remote
control. The yellow light under the LEARN key should
start to flash; if not, the remote controls should be moved
closer together.
3. Gradually increase the distance between the two remote
controls, making sure they are still in line with each other,
until the yellow light under the LEARN key stops flashing.
This indicates the maximum distance for data exchange between the two remote controls. In order
to copy the signals the remote controls must be positioned at half this distance, taking care not to move
them until the process is completed.
4. Briefly press the selection key of the required appliance.
5. Briefly press the LEARN key together with one of the
keys F1 - F2 - F3 - F4, or any other key on which you
want to memorize the function to be copied.
6. The yellow light of the LEARN key will light up and stay
lit while waiting to receive a signal from the original
remote control.
7. Press the key on the original remote control corresponding
to the signal to be copied and hold it down until the
yellow light of the LEARN key goes out.
Important: if the light of the LEARN key lights up again when the key is released, the same key on the
original remote control must be pressed again until the light goes out again. It may be necessary to
repeat this operation a third time.
8. The procedure is complete when the red light of the
selected appliance emits three long flashes. Only then
will the remote control be ready to copy other signals to
be assigned to other keys.
After programming the LEARN 5 in 1 remote control, whenever a key that has been assigned a LEARN
command is pressed, not only will the light of the key relative to the appliance being used light up, but
also the light of the LEARN key.
12
LEARN
CME
LEARN LEARN LEARN
max dist.
LEARN LEARN LEARN LEARN
or or
+
or
LEARN
LEARN
LEARN
original
LEARN LEARN
LEARN LEARN LEARN
or or
...
or or