Learn Function - CME Toptel 5 Gebrauchsanleitung

To find out the code of your remote control, follow this procedure:
1. Press the select key for which you want to know the code
and hold down for 5 seconds.
2. When the key is released it will start to flash; press and
release the 1-/-- key within 8 seconds.
3. After a pause of several seconds, the indicator light produces
four series of flashes with a space between them, corres-
ponding to the code you are looking for. Count the number
of flashes; each series of flashes corresponds to one figure
in the code. 10 flashes correspond to 0.
4. Note the code on the adhesive label inside the battery cover
in case you have to reprogramme the remote control subse-
quently.
NB: this operation cannot be interrupted and the remote control
cannot therefore be used until the end of the four series of flashes.
If you know the exact code with which to programme the remote control, enter it as follows:
1. Hold down the selection key for the appliance to be
programmed for 5 seconds.
2. When the key is released it will start to flash; enter the
code ( e.g. TV 1306 ). Three flashes indicate that the
operation has been completed correctly.
The functions Mute , Vol - , Vol + and AV are memorized on the keys F1 , F2 , F3 , F4 . These functions
can be used to control appliances other than the TV. For further information consult the on-line guide
on the site www.cme.it
the remote control you want to copy the signal from must still work.
L1
Learn the missing functions of an original remote control and memorize them on the keys F1 -
F2 - F3 - F4 or on any other key and thus replace the original remote control.
Learn all the functions of a new remote control introduced subsequently and thus not yet included
L2
in the database of the universal remote control.
Learn the missing functions of an original remote control and
L1
memorize them on any key of the LEARN 5 in 1 remote control.
the remote controls must first be placed the correct distance apart.
1. Position the original remote control in front of the universal
remote control, so that the areas that emit the infrared
signals are opposite each other and about 5 cm apart.
CU RRE N T COD E D ISPL AY
ENTERING THE CODE
TV FUNCTIONS ALWAYS ACTIVE

LEARN FUNCTION

To use this function,
This function allows the remote control to:
NB: A maximum of 85 functions can be learnt.
To copy the signals,
or or or
......................................................... = 1
.............................................. = 3
............................ = 6
Code obtained = 1306
or or or
1 1 3
+ +
5 cm
CME
5 SEC.
or
= 0
5 SEC.
or
0 6
+
original
11