Electrical Connection - Zanussi zrt 16 jc Gebrauchsanleitung

holders (3 pieces) respectively the screw on the other
side.
Put over the pin in the lower door holding plate in the
direction of the arrow.
Fix the plate on the other side leaving the position of
the door unchanged.
Then screw in the one screw in the place set free on
the other side as well as the adjustable feet (2
pieces) and set up the box.
For refitting the upper door holder take out the screws
(2 pieces) fixing the plastic top on the back of the
box.
Push back the top and lift it from the fixing elements.
Unscrew the screws fixing the upper door holder (2
pieces).
After unscrewing turn over the pin in the door holder
plate in the direction of the arrow.
Fit and fix the door holder plate on the other side with-
out displacing the door.
Put back the plastic top on the fixing elements and
pull it forward.
Fix the top with the screws (2 pieces) on the back
side of the box.
Put over the handle and the plastic nails on the other
side.
Put the appliance to its place, set it level and plug it
into the mains socket.
In case you do not want to perform the procedures above,
call the nearest brand-mark service. Technicians will
accomplish the refitting expertly for charge.

Electrical connection

This refrigerator is designed to operate on a
230 V AC ( ~ ) 50 Hz supply.
The plug must be put into a socket with protective
contact. If there is no such, it is recommended to get
an electrician to fit an earthed socket in compliance
with standards near the refrigerator.
This appliance complies with the following E.E.C.
Directives:
73/23 EEC of 19.02.73 (Low Voltage Directive) and
subsequent modifications,
89/336 EEC of
Compatibility Directive) and subsequent modifica-
tions.
GB
03.05.89 (Electromagnetic
43