Appliance Self-Test; Starting The Appliance Self-Test; Ending The Appliance Self-Test - Siemens gs..v serie Gebrauchsanleitung

Fault
Temperature differs
greatly from the set
value.
Appliance is not
cooling, temperature
display and light
are lit.

Appliance self-test

Your appliance features an automatic
self-test program which shows you
sources of faults which may be repaired
by customer service only.

Starting the appliance self-test

1. Switch off the appliance and wait
5 minutes.
2. Switch on the appliance and hold
down the temperature selection
button, Fig. 2/4, for 3-5 seconds
within the first 10 seconds until -26 °C
is lit on the temperature display.
The self-test programme starts, when
the temperature displays lit up
in succession.
Possible cause
Showroom mode is
switched on.
Remedial action
In some cases it is adequate
to switch off the appliance
for 5 minutes.
If the temperature is too high wait
a few hours and check whether
the temperature has approached
the set value.
If the temperature is too low check
the temperature again the next day.
Hold down temperature selection
button 2/4 for 10 seconds until
an acknowledgement signal sounds.
After a short time check whether
your appliance is cooling.
When after a short time the appliance
displays the set temperature prior
to the self-test, everything is ok.
If the super display flashes for
10 seconds, an error has occurred.
Inform customer service.

Ending the appliance self-test

When the programme has ended, the
appliance switches over to normal
operation.
en
35