Appliance Self Test; Starting The Appliance Self Test; Ending The Appliance Self Test; Customer Service - Bosch KAN Serie Gebrauchs- Und Montageanleitung

en
Fault
Temperature differs greatly
from the set value.
E.." is indicated on
the display panel.
Warning signal sounds and
the temperature display on
the freezer compartment
flashes.
No display on the display
panel.
The interior light is not
functioning.
The appliance becomes
slightly louder for a brief
period.
Appliance has no
refrigerating capacity.
The interior light is not
functioning.
The refrigerating unit
is switching on more
frequently and for longer.
The temperature in the
refrigerator or freezer
compartment is too cold.
The frozen food is frozen
solid.

Appliance self test

Your appliance features an automatic
self test program which shows you
sources of faults which may be repai
red by customer service only.
Starting the appliance
self test
S Switch off the appliance and wait
5 minutes.
28
Possible cause
Electronics module defective.
The freezer compartment is too warm! Frozen food is at
risk!
S The ventilation openings have been covered.
S Freezer compartment door is open.
S Too much food was placed in the freezer
compartment at once.
The mains plug of the appliance is not in the socket
properly. The fuse for the domestic supply is switched
off.
The light switch for the freezer or refrigerator
compartment is sticking.
The light (LED) is defective.
Not a fault! Your appliance is designed to save energy. Under certain conditions (e.g. activation of the Super function)
the appliance must work harder for a brief period and therefore becomes slightly louder.
Power failure; the fuse has been switched off;
the mains plug has not been inserted properly.
Appliance door opened frequently.
Large quantities of fresh food are being frozen.
The ventilation openings have been covered.
Temperature has been set too low.
S Switch on the appliance again.
S Simultaneously press button +" and
-" button for 5 seconds.
The self test programme starts. If E.."
is indicated on the display panel,
an error has occurred. If a fault is
indicated, inform customer service.

Ending the appliance self test

S Press the +" and -" buttons again
for 5 seconds.
Remedial action
In some cases it is adequate to switch off the appliance for
5 minutes.
If the temperature is too high, wait a few hours and check
whether the temperature has approached the set value.
If the temperature is too low, check the temperature again
the next day.
Call Customer service.
Press the alarm off/lock" button to switch off the warning
signal and the flashing display.
The warmest temperature reached in the freezer
compartment is indicated on the temperature display of the
freezer section for 10 seconds.
Note: Frozen food which has started thawing or which has
thawed can be refrozen if meat and fish were above +3 °C
for not more than one day or other frozen food was above
+3 °C for not more than three days.
Check whether the power is on, the fuse must be switched
on.
Check whether the light switch can move.
See chapter Light".
Check whether the power is on, the fuse must be switched
on.
Do not open the door unnecessarily.
Do not exceed max. freezing capacity.
Remove obstacles.
Select a warmer temperature (see Setting the
temperature").
Loosen frozen food with a blunt object. Do not use a knife or
pointed object.

Customer service

Your local customer service can be
found in the telephone directory or in
the customer service index. Please
provide customer service with the ap
pliance product number (E Nr.) and
production number (FD).
This information can be found on the
product label.2