Technical Information - Progress PV1545 Benutzerinformation

16 Progress
Problem
The dishes are wet.
The interior of the appliance is
wet.
Unusual foam during washing.
Traces of rust on cutlery.
There are residues of detergent
in the dispenser at the end of
the program.
Odours inside the appliance.
Limescale deposits on the ta-
bleware, on the tub and on the
inside of the door.
Dull, discoloured or chipped ta-
bleware.
Refer to "Before first use",
"Daily use" or "Hints and
tips" for other possible causes.

TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
Possible cause and solution
• The programme does not have a drying phase or has a
drying phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• This is not a defect of the appliance. it is caused by the
humidity in the air that condenses on the walls.
• Use the detergent for dishwashers only.
• There is a leak in the rinse aid dispenser. Contact an Au-
thorised Service Centre.
• There is too much salt in the water used for washing. Re-
fer to "The water softener".
• Silver and stainless steel cutlery were placed together.
Avoid to put silver and stainless steel items close together.
• The detergent tablet got stuck in the dispenser and there-
fore was not completely washed away by water.
• Water cannot wash away the detergent from the dispens-
er. Make sure that the spray arm is not blocked or clog-
ged.
• Make sure that items in the baskets do not impede the lid
of the detergent dispenser from opening.
• Refer to "Internal cleaning".
• Refer to "The water softener".
• Make sure that only dishwasher-safe items are washed in
the appliance.
• Load and unload the basket carefully. Refer to basket
loading leaflet.
• Place delicate items in the upper basket.
Width / height / depth (mm)
Voltage (V)
1)
Frequency (Hz)
Min. / max. bar (MPa)
596 / 818-898 / 555
220 - 240
50
0.5 (0.05) / 8 (0.8)