Tips For Use; Before Taking Into Use - Silvercrest SDLTD 1400 A1 Bedienungsanleitung

Tips for use

■ Each of the two toaster slots
or one bread slice 120 x 120 mm.
■ Avoid using slices that are too big or too thick, as these can easily become
jammed in the appliance. Should slices of bread become jammed, first
disconnect the plug from the mains power socket. Release jammed slices
of bread with a blunt wooden object (e.g. a wooden spatula or spoon).
Thereby, do NOT touch the heater elements.
■ Differences in bread sorts, moisture content and the thickness of individual
slices influence the browning of the toast. Therefore the bread for toasting
should be kept in sealed packaging until required. Always initially try out
a lower level of browning.
■ Use a lower level of browning if you are toasting dry bread, as dry bread
browns faster than fresh bread.
■ Set a lower level of browning if you are toasting less than 4 bread slices.
■ Select a higher level of browning for dark bread than for light bread, for
example, wheat bread.
■ To avoid an overheating of the toaster and to obtain an even browning
of bread, wait for about 15 seconds between two toasting processes.
■ You should only use the highest level on the toasting dial
of dark bread. With this browning level light bread will scorch and become
inedible. In addition, it may cause the generation of smoke. If this occurs,
press the button "Stop"
from the mains power socket.

Before taking into use

■ Operate the toaster without bread for 3 times at the maximum browning
level (IIIII).
■ Afterwards, clean the toaster as described in the chapter "Cleaning".
NOTICE
► The operating slide
mains power socket.
► With the first usage a slight smell can arise (minimal smoke development is
also possible). This is normal and dissipates after a short time. Provide for
sufficient ventilation. For example, open a window.
■ 6 │
GB
are suitable for either 2 bread slices 90 x 90 mm,
immediately and disconnect the power cable
only engages when the cable is connected to a
for large slices
SDLTD 1400 A1