Starting Up - AUDIOLINE OSLO 100 Bedienungsanleitung

2

Starting Up

2.1 Safety information
Caution: It is essential to read the Safety Information in Chapter 1 before starting up.
2.2 Checking the contents of the package
The package contains:
a base station
a handset
a power adapter plug
2.3 Connecting the base station
Connect the base station as illustrated in the dia-
gram. For reasons of safety, only use the power
adapter plug and telephone connection line supplied.
The power adapter plug from the base station must
always be connected to a properly installed 230 V
mains power outlet.
2.4 Inserting the batteries
Insert two batteries of the type AAA Ni−MH 1.2 V 550 mAh
in the battery compartment after opening it. Pay attention
to correct polarity (refer to Fig.)! Close the battery compart-
ment cover.
Important: Do not use any other type of batteries.
2.5 Charging the batteries
When preparing to use the handset for the first time, place it in the base station (display facing up-
wards) for at least 14 hours. The charging control lamp on the base station lights up. The handset
warms up during the charging process. This is normal and does not represent a risk. Do not
charge the handset with charging units from other manufacturers. Failure to charge the batteries
properly can lead to telephone malfunction.
The current battery charge status is indicated in the display:
Full
The handset has a standby time of max. 110 hours when at room temperature and with fully
charged batteries. The maximum talk time is 10 hours.
2.6 Tone or Pulse dialling mode
The telephone can be connected to both analogue connections (pulse dialling) and digital con-
nections (tone dialling). The equipment is set to Tone dialling mode at the factory. If the telephone
does not work on your telephone connection, refer to Chapter 7.3 to learn how to switch the tele-
phone to analogue, pulse dialling mode.
2.7 Operating on private branch exchanges
If your telephone is connected to a private branch exchange, the R button can be used to imple-
ment the transfer calls or automatic callback functions. When used on a private branch exchange,
a Recall time of 100 ms must be set. The dealer where you purchased the exchange can provide
information as to whether the telephone will work properly with the exchange.
2.8 Supplementary services from your telephone network provider
The AUDIOLINE telephone supports all major supplementary services offered by the telephone
network provider (e.g. brokering, call waiting, three−way conferencing, etc.). If the T−Net functions
from Deutschen Telekom are available for you, set the Recall (Flash) time to 300 ms (refer to Sec-
tions 7.3 and 12.3). Press the R button to use the T−Net services. Please contact the telephone
network provider with regard to enabling the supplementary services.
− Starting Up −
a telephone connection cable
two rechargeable batteries
an operating manual
Half empty
230 V
50 Hz
TAE−F
Low Empty
27