AEG LP5481 Benutzerinformation Seite 28

28 www.aeg.com
• - The anti-flood device is on.
Disconnect the appliance and close
the water tap. Contact the Authorised
Service Centre.
13.2 Possible failures
Problem
The programme does
not start.
The appliance does not
fill with water properly.
The appliance fills with
water and drains immedi-
ately.
The appliance does not
drain the water.
Possible solution
Make sure that the mains plug is connected to the mains sock-
et.
Make sure that the appliance door is closed.
Make sure that there is not a damaged fuse in the fuse box.
Make sure that the Start/Pause has been touched.
If the delay start is set, cancel the setting or wait for the end of
countdown.
Deactivate the Child Lock function, if it is on.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter of the inlet hose and the filter of the
valve are not clogged. Refer to 'Care and cleaning'.
Make sure that the water inlet hose has no kinks, damages or
bends.
Make sure that the connection of the water inlet hose is cor-
rect.
Make sure that the drain hose is in the correct position. The
hose may be positioned too low (see 'Water drainage' para-
graph).
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Make sure that the drain filter is not clogged. Clean the filter, if
necessary. Refer to 'Care and cleaning'.
Make sure that the connection of the drain hose is correct.
Set the drain programme if you set a programme without drain
phase.
WARNING!
Deactivate the appliance
before carrying out any
check.