Controls; Controls On The Frontpanel - Adam Sub7 Bedienungsanleitung

On the front side you will find two potentiometer, one for the volume and one
for the crossover frequency. Both the volume and the frequency can also be
controlled by the remote control. On the rear side, there are more controls
(satellite filter, phase switch, mode). The following tips are intended to assist
you at using the controls in the best manner.
6.1 Controls on the front panel & Remote control
Volume
a)
Input Sensitivity control from -60 dB to +6 dB
relative to 775 mV when used via the symmetrical
XLR input or relative to 250 mV when used via the
asymmetrical Cinch (RCA) input.
b) Frequency:
The upper frequency limit of the unit is variable and
can be set to any value between 50 and 150Hz.
The 85Hz marker indicates the recommendation
of Dolby® labs for surround sound settings. In
many cases, a slightly lower crossover frequency
delivers tighter bass response, for typical near-
midfield monitors we recommend 70 to 75Hz
as upper limit (i.e. -3 dB point in the frequency
response).
Please note: If you alter the frequency it is
advisable to try if an alteration of the phase
improves the sound quality.
8
6.

Controls

fig. 4: Frontpanel
+
FREQ
+
VOLUME
fig. 5: Remote control