Important Information For Set Up - Adam Sub7 Bedienungsanleitung

Important information for set up

Acclimation:
a)
After having unpacked your subwoofer, please allow the system to acclimate
to the temperature of the room for approximately an hour.
Solid stand:
b)
It is important to ensure the subwoofer sits firmly on a solid surface!
Transportation/packaging:
c)
We recommend that you retain the original packaging, as it is the best way to
guarantee safe transportation should the need to do so arise (see ).
Break-in time:
d)
Please note that the subwoofers will take some break-in time to achieve
optimum sonic performance.
Danger from high SPLs:
e)
Exposure to high sound pressure levels may cause permanent hearing
loss! Please do not get close to the subwoofers when using them at high
volumes.
f) Placement:
Please note, that for a seamless integration between the subwoofer and the
main speakers, placement is very important (see p. 7).
LEDs:
g)
There are two LEDs on the front, one on each potentiometer.
The left one will blink a few times red when the subwoofer is being switched
on. This does not indicate an overload but the control function of the
protective circuit. Only if the diode flashes red during operation this indicates
an overload. Afterwards, the diode glows green.
The right diode will glow green during operation and yellow during stand-by
(signal-on-mode, see 6.2).
LED 1: blinks red a
few times when sub is
switched on
3.
Information for Set Up
fig. 1: LEDs
LED 2: green, indicating
operation; turns yellow
in stand-by-mode
5