Electric Connection; The First Wash Cycle; Technical Details - Indesit WIXL 84 Bedienungsanleitungen

Connecting the drain hose

We advise against the use of hose extensions; in
case of absolute need, the extension must have the
same diameter as the original hose and must not
exceed 150 cm in length.

Electric connection

Before plugging the appliance into the mains
socket, make sure that:
• the socket is earthed and in compliance with the
applicable law;
• the socket is able to sustain the appliance's
maximum power load indicated in the Technical
details table (on the right);
• the supply voltage is included within the values i
ndicated on the Technical details table
(on the right);
• the socket is compatible with the washing
machine's plug. If this is not the case, replace
the socket or the plug.

The washing machine should not be installed in an
outdoor environment, not even when the area is
sheltered, because it may be very dangerous to
leave it exposed to rain and thunderstorms.

When the washing machine is installed, the mains
socket must be within easy reach.
Connect the drain hose,
without bending it, to a
draining duct or a wall
drain situated between
65 and 100 cm from
the floor;
alternatively, place it
over the edge of a
basin, sink or tub,
fastening the duct
supplied to the tap (see
figure). The free end of
the hose should not be
underwater.

Do not use extensions or multiple sockets.

The power supply cable must never be bent or
dangerously compressed.

The power supply cable must only be replaced by
an authorised serviceman.
Warning! The company denies all liability if and when
these norms are not respected.

The first wash cycle

Once the appliance has been installed, and before
you use it for the first time, run a wash cycle with
detergent and no laundry, setting the 90°C
programme without a pre-wash cycle.

Technical details

Model W IX L 84
59.5 cm w id e
Dimensions 85 cm high
53.5 cm d eep
Capacity from 1 to 6 kg
Electric voltage 220/230 Volt s 50 Hz m ax imu m
connections ab s orb ed p ow er 1850 W
m ax imu m p res s u re 1 MP a (10 b ar)
Water
m inim um p res s ure 0.05 M P a (0.5 b ar)
connections
d rum cap acity 52 lit res
Spin speed up to 800 rp m
Control
programmes p rogram me 2; t em p eratu re 60°C;
according to ru n with a load of 6 kg.
IEC456 directive
Th is ap p liance is comp lian t with t he
following E urop ean Comm un ity
Directives :
- 73/23/CEE of 19/02/73 (Low
Voltage) and s ub s eq uen t am end m en ts
- 89/336/CEE of 03/05/89
(Elect rom agnet ic Com p atib ility) and
s u b s eq uent am end ments
- 2002/96 CE
GB
27