Comtel One Digital Bedienungsanleitung Seite 40

Parent unit
1. Set the power ON-OFF switch 15 to ON position to turn on the unit. The
power on indicator 19 will light up steady red.
2. Place the parent unit at a reasonable distance away from the baby unit
to avoid feedback. Too close a distance will create a screeching sound at
the speaker 22.
3. Once the unit receives a signal, the LEDs in the level meter 16 will light
up. The louder the baby's voice, the more number of LED will be lighted up.
This feature is useful in case the parents prefer to turn down the speaker
volume to keep the environment quiet.
4. The speaker volume can be adjusted using the volume +/- button 13 &
14. Each press of these buttons will create a beep sound and
to will
light up correspondingly in the temperature indicator 20 .
means the
speaker is completely muted and means maximum volume.
5. This unit is equipped with a vibration alert. Set the power ON/OFF switch
15 to position , the vibration indicator 18 will light up. Once baby's voice
is received, the vibrator starts functioning. This feature is useful when the
parent is working under very noisy environment (e.g. vacuum cleaning). To
save battery power, it is recommended not to use the vibration alert
frequently.
6. Once the parent unit is beyond the communication range of baby unit for
over 2 minutes, an out-of-range alarm will be heard together with the LED
level meter 16 starts flashing to alert the parents. The alarm will go off only
when the parent unit falls back within the communication range of baby
unit.
N.B. This alarm will also be heard in case the baby unit is switched off, or
its battery has run down, or its power is cut off, or pairing process is not
successful.
7. The condition of the battery (or rechargeable battery pack) is shown by
the power on/battery low indicator 19. When the battery runs down, the
indicator 19 starts flashing and an alarm will be heard, reminding the
parents to replace the battery (or charge up the battery pack using the
rapid charger).