Comtel One Digital Bedienungsanleitung Seite 38

PAIRING
This process is to match the parent unit with baby unit so that they can
communicate with each other while no other devices (even baby monitor of
identical model) can interfere with you or receiving your signal.
The baby and parent unit are already paired with factory preset code when
they are shipped from factory. However, we recommend to perform pairing
again to achieve better privacy:
14 of parent unit.
1. First press and hold the button
2. Set the power ON-OFF switch 15 to ON position and wait until the
Temperature indicator 20 show a flashing.
button 3 of baby unit.
3. Now press and hold the
4. Set the power ON-OFF switch 4 to ON position and wait until the Tx
indicator 8 starts flashing.
5. Release button 3 and then press and hold button 3 again.
6. If pairing is successful, the on the Temperature indicator 20 and the Tx
indicator 8 should stop flashing, at the same time, 2 beep sound will be
heard from the parent unit.
7. Switch off both baby and parent units and then switch them on again, the
baby monitor is now ready for operation.
8. In case the baby and parent unit cannot communicate with each other,
repeat steps 1 - 7 again.