Basics; Faceplate; Getting Started; Select The Display Language And Cancel The Demonstration - Kenwood KDC-X5100BT Bedienungsanleitung

BASICS

Faceplate

Volume
knob
Detach
button
Auxiliary cable from USB cable from the
the rear of the unit. rear of the unit.
Attach Detach
To
Turn on the power
Adjust the volume
Select a source
Change the display information
Display Lights up when Bluetooth
window connection is established. ( 10)
Flashes when the unit
enters searching status.
How to reset
On the faceplate
Press .
• Press and hold to turn off the power.
Turn the volume knob.
Press repeatedly.
Press DISP repeatedly. ( 25)

GETTING STARTED

1
Select the display language and cancel the
demonstration
When you turn on the power for the first time
(or [FACTORY RESET] is set to [YES],
"SEL LANGUAGE" "PRESS" "VOLUME KNOB"
1
Turn the volume knob to select [ENG] (English), [RUS]
(Russian) or [SPA] (Spanish), then press the knob.
[ENG] is selected for the initial setup.
Then, the display shows: "CANCEL DEMO" "PRESS"
"VOLUME KNOB".
2
Press the volume knob.
[YES] is selected for the initial setup.
3
Press the volume knob again.
"DEMO OFF" appears.
Then, the display shows the selected crossover type:
"2-WAY X ' OVER" or "3-WAY X ' OVER"
• To change the crossover type, see "Change the crossover
type". ( 5)
5), the display shows:
3
ENGLISH