References; Maintenance; More Information - Kenwood KDC-X5100BT Bedienungsanleitung

TROUBLESHOOTING
Symptom Remedy
Echo or noise is heard • Adjust the microphone unit's position. ( 10)
during a phone • Check the [ECHO CANCEL] setting. ( 12)
conversation.
Phone sound quality • Reduce the distance between the unit and the Bluetooth device.
is poor. • Move the car to a place where you can get a better signal reception.
• Use voice calling method in a more quiet environment.
Voice calling method is
• Reduce the distance from the microphone when you speak the
not successful.
name.
• Make sure the same voice as the registered voice tag is used.
• Reduce the distance between the unit and the Bluetooth audio
Sound is being
interrupted or skipped player.
• Turn off, then turn on the unit and try to connect again.
during playback of a
• Other Bluetooth devices might be trying to connect to the unit.
Bluetooth audio player.
The connected Bluetooth • Check whether the connected Bluetooth audio player supports
audio player cannot be Audio/Video Remote Control Profile (AVRCP). (Refer to the
controlled. instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
"DEVICE FULL" The number of registered devices has reached its limit. Retry after
deleting an unnecessary device. ( 14, DEVICE DELETE)
"N/A VOICE TAG" Make sure the same voice as the registered voice tag is used.
"NOT SUPPORT" The connected phone does not support Voice Recognition feature or
phonebook transfer.
"NO ENTRY"/"NO PAIR" There is no registered device connected/found via Bluetooth.
"ERROR" Try the operation again. If "ERROR" appears again, check if the device
supports the function you have tried.
"NO INFO"/"NO DATA" Bluetooth device cannot get the contact information.
"HF ERROR XX"/ Reset the unit and try the operation again. If this does not solve the
"BT ERROR" problem, consult your nearest service center.

REFERENCES

Maintenance

Cleaning the unit
Wipe off dirt on the faceplate with a dry silicone or soft cloth.
Cleaning the connector
Detach the faceplate and clean the
connector gently with a cotton swab,
being careful not to damage the
connector.
Handling discs
• Do not touch the recording surface of the disc.
• Do not stick tape etc. on the disc, or use a disc with tape stuck on it.
• Do not use any accessories for the disc.
• Clean from the center of the disc and move outward.
• Clean the disc with a dry silicone or soft cloth. Do not use any solvents.
• When removing discs from this unit, pull them out horizontally.
• Remove burrs from the center hole and disc edge before inserting a disc.

More information

For: – Latest firmware updates and latest compatible item list
– KENWOOD original application
– Any other latest information
Visit <www.kenwood.com/cs/ce/>.
General
• This unit can only play the following CDs:
• For detailed information and notes about the playable audio files, visit
<www.kenwood.com/cs/ce/audiofile/>.
Connector (on the reverse
side of the faceplate)
23
ENGLISH