Starting A Warm Engine - Shindaiwa AHS2510 Bedienungsanleitung

Engine operation
1. Choke lever
2. Cold Start
1. Starter handle
Engine warm-up

Starting a warm engine

1. Ignition switch
2. Throttle trigger
3. Throttle trigger lockout
3. Run
4. Throttle latch
5. Start
8. Checking that the area around you is safe, hold the front
handle firmly with your right hand as shown in the illustration,
pulling several times on the starter grip.
9. If you hear an explosion-like sound and the engine stops im-
mediately, move the choke lever to the "Run" position and
continue pulling on the starter grip to start the engine.
10. If the engine starts immediately when you carry out the in-
structions in step 8, above, return the choke lever gently to
the "Run" position.
11. Leave the engine to warm up at idle speed for a while.
12. Depress the throttle trigger lockout and gradually squeeze
the throttle trigger.
IMPORTANT
If the engine fails to start after several attempts with the choke
in the closed position, the engine may be flooded with fuel.If
flooding is suspected, move the choke lever to the open posi-
tion and repeatedly pull the recoil starter to remove excess fuel
and start the engine. If the engine still fails to start, refer to the
troubleshooting section of this manual.
1. Once the engine starts, allow it to warm up for 2 to 3 minutes
at idling (i.e. low speed).
2. Warming the engine helps to lubricate its internal workings
more smoothly. Allow the engine to warm up fully, especially
when it is cold.
1. Move the ignition switch to the Start position.
2. Make sure that the throttle trigger is at the idle speed posi-
tion.
20