Engine Operation; Starting The Engine; Starting A Cold Engine - Shindaiwa AHS2510 Bedienungsanleitung

Starting the engine

When starting the engine, observe the precautions described from Page 4in the section "For safe use of your prod-
uct" to ensure that you operate the product correctly.
The attachment will operate immediately when the engine starts and could result in loss of control and possible se-
rious injury. Keep movable parts of the attachment off the ground and away from objects that could become entan-
gled or thrown.
If the blades moves even though the throttle trigger is in the idle speed position when the engine is started, adjust
the carburettor before using the product.
Blades will start moving as engine attains clutch engagement speed.
Failure to observe the precautions could cause an accident or injury, or even lead to a fatality.
NOTE
Pull out the starter grip gently at first, and then more rapidly. Do not pull the starter rope out to more than 2/3 of its length.
Do not let go of the starter grip as it returns.

Starting a cold engine

1. Ignition switch
2. Throttle trigger
3. Throttle trigger lockout
1. Purge bulb
WARNING
4. Throttle latch
5. Start

Engine operation

Engine operation
(Connect the spark plug cap if the product has been in storage for
a long period of time)
The starting procedure depends on whether the engine is cold or
warm. A cold engine is started as follows.
1. Remove the blade cover and check the cutter blades. If an-
ything is wrong, replace it with a new one.
2. Placing the product on level ground, check to ensure that the
blades does not come into contact with the surface of the
ground or any other impediment using a beam or other such
implement.
3. Check that there are no fuel leaks.
4. Move the ignition switch to the Start position.
5. Set the throttle trigger to the latch lock position by performing
the following:
(1) Depress and hold the throttle trigger lockout, and then
squeeze the throttle trigger.
(2) Depress and hold the throttle latch.
(3) While depressing the throttle latch, release the throttle
trigger lockout and throttle trigger.
6. Move the choke lever to the "Cold Start" position.
7. Alternately press and release the purge bulb until the fuel is
sucked up into it.
19