Initial Operation; Working Advice - Bosch ISIO Originalbetriebsanleitung

OBJ_BUCH-904-002.book Page 25 Thursday, August 5, 2010 2:57 PM
The battery charge-control indicator 2 indicates
the charging progress. During the charging proc-
ess, the indicator flashes green. When the bat-
tery charge-control indicator 2 lights up green
continuously, the battery is fully charged.
During the charging procedure, the handle of
the garden product warms up. This is normal.
Disconnect the battery charger from the mains
supply when not using it for longer periods.
The garden product cannot be used during the
charge procedure; it is not defective when inop-
erative during the charging procedure.
Protect the battery charger against mois-
ture!
Pole cart (accessory or supplied with
"Grass Shear & Pole Cart")
The pole cart is designed only for use with
the grass shear at ground level.
Do not use the pole cart with the shrub
shear or above ground level.
Removing Pole Cart (see figure B)
Unplug the handle connector 10.
To release the garden product from wheel
cart 12, pull the garden product in the direc-
tion shown.
Fitting Pole Cart (grass shear only)
Align the grooves on the garden product with
fixing on the wheel cart 12.
Plug in the handle connector 10.
Adjusting Handle Length (see figure C)
Loosen the adjustment collar 9.
Pull the telescopic pipe 8 out to increase the
height, or push it in to decrease the height.
Re-tighten adjustment collar 9.
Adjusting for Edging Mode (see figure D)
Turn the garden product 90 °, in either direction
to position the garden product in the vertical
edging mode.
Bosch Power Tools
Operation

Initial Operation

Switching On
Press the lock-off button 6 and hold while actu-
ating the On/Off switch 5.
Release the lock-off button 6 again.
Switching Off
Release the On/Off switch 5.
Battery Charge-control Indication
The battery charge-control indicator 2 indicates
the charge condition of the battery for a few sec-
onds when the On/Off switch 5 is pressed
through halfway of fully.
LED
Continuous lighting, green
Flashing light, green
Flashing light, red
Continuous lighting, red

Working Advice

Hold the garden product away from your-
self. Stand in a secure and stable position.
For more tips on cutting please refer to
website www.bosch-garden.com.
Anti Blocking
The garden product has a patented feature
which works as follows:
If the blade stalls on a tough material, the load
of the motor increases. The intelligent micro-
electronics senses this overload condition and
repeatedly reverses the motor, in order to pre-
vent stalling and to cut the material through.
This audible reversing cut action continues for
up to 3 s.
After cutting through, the garden product con-
tinues in its normal mode, or in case the over-
load condition continues the blades automati-
cally stop in the open position (e. g. in case a
piece of metal fence accidentally blocks the gar-
den product).
English | 25
Capacity
≥35%
15 – 35%
5 – 15%
≤5%
F 016 L70 633 | (5.8.10)