Siemens TE 501 Serie Gebrauchsanleitung Seite 41

Problem
D
LED flashes.
The coffee grounds are
not compact and are too
wet�
I
LED flashes.
Coffee or milk froth quality
varies widely.
Water dripped onto the
inner floor of the appli­
ance when the drip tray
(8) was removed�
The default settings have
been changed and need
to be reset�
LEDs flash.
LEDs flash.
LEDs flash.
If you are unable to solve the problem, please call the hotline.
You will find the telephone numbers at the back of these instructions.
Cause
The water tank is not
correctly installed or the
filter is worn.
Carbonated water in the
water tank�
The grind setting is too
fine or too coarse, or not
enough ground coffee has
been used�
Brewing unit (5) is soiled�
Too much pre­ground
coffee in the
brewing unit (5)�
The brewing unit
mechanism is stiff�
Brewing unit (5) is missing
or has not been detected�
Build­up of limescale in the
appliance�
Drip tray (8) removed too
soon�
Some settings have been
made that are no longer
required�
The appliance has a fault�
Incorrect voltage.
The ambient temperature is
too cold�
Remedy
Correctly install the water tank.
If the LED continues to flash,
install a new filter and rinse, see
chapter "Filter".
Fill the water tank with fresh tap
water�
Adjust the grinding unit to a
coarser or finer setting, or use
2 level measuring spoons of
ground coffee�
Clean the brewing unit (5)�
Clean the brewing unit (5) Put in
no more than 2 level measuring
spoons of ground coffee�
Remove and clean the brewing
unit, see "Maintenance and daily
cleaning".
Switch off the appliance with the
brewing unit (5) in place, wait
three seconds and switch on the
appliance again�
Descale the appliance as
described in the instructions�
Wait a few seconds after the
last drink was dispensed before
removing the drip tray (8).
Press the power on/off button O / I
(9) to switch off the appliance�
Press and hold the service button
(12) and the steam button (11)
and press the power on/off button
O / I (9) to switch on the appliance�
Then press the start button (10) to
confirm. The default settings are
reset�
Please contact the hotline�
Operate the appliance at
220 V­240 V only.
Operate the appliance at
temperatures > 5° C.
en
37