Siemens TE 501 Serie Gebrauchsanleitung Seite 31

If you wish to change the default degree of
water hardness, or if you have inserted a
water filter, proceed as follows:
1� Turn the rotary
knob (13) to position
2� Press and hold buttons
A
(12) simultaneously for at least
5 seconds� The set water hardness is
indicated by the number of LEDs that
now light up�
3� Now press the start button (10) repeat­
edly until the required water hardness
is indicated, e� g�, for water hardness 3,
D E
LEDs , and
4� Press and hold the start button (10)
for at least 5 seconds� The set number
of LEDs will light up to indicate that
the selected water hardness has been
saved successfully.
Important: If a water filter is used (see
"Accessories"), proceed as follows, see
"Water filter".
Note: If no button is pressed within
90 seconds, the appliance switches to
stand­by mode without saving the new
settings. In this case, the previously saved
water hardness setting is retained�
Automatic switch-off
Here you can set the period of time after
which the appliance should switch off
automatically following the last drink
preparation� A time between 15 minutes and
4 hours can be set� To save power you can
specify a shorter period.
1� Turn the rotary
knob (13) to position
2� Press and hold buttons
A
(12) simultaneously for at least
5 seconds� The time after which the
appliance should switch off is indicated
by the number of LEDs that now light up.
B
(11) and
F
will light up�
B
(11) and
3� Now press the start button (10) repeat­
edly until the required number of LEDs
light up to indicate the switch­off time:
D
= 15 minutes
D E
and = 30 minutes
D E F
, and = 45 minutes
D E F G
, , and
D E F G
, , , and
D E F G
, , , ,
4� Press and hold the start button (10) for
at least 5 seconds� The set number of
LEDs will light up to indicate that the
selected switch­off time has been saved
successfully.
Note: If no button is pressed within
90 seconds, the appliance switches to
stand­by mode without saving the new
settings. In this case, the previously saved
switch­off time is retained.
Setting the brewing temperature
The brewing temperature can also be set�
1� Turn the rotary
knob (13) to position
2� Press and hold buttons
A
(12) for at least 5 seconds� The set
brewing temperature is indicated by the
number of LEDs that now light up�
3� Now press the start button (10) repeat­
edly until the required number of LEDs
light up to indicate the temperature:
D
LED = low
D E
LED and
D E
LED , ,and
4� Press and hold the start button (10) for
at least 5 seconds� The set number of
LEDs will light up to indicate that the
selected temperature has been saved
successfully.
Note: If no button is pressed within
90 seconds, the appliance switches to
stand­by mode without saving the new
settings. In this case, the previously saved
brewing temperature setting is retained�
= 1 hour
H
= 2 hours
H I
and = 4 hours
B
(11) and
= medium
F
= high
en
27