Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Cooling Beverages; Illumination - Silvercrest SMB 140 A1 Bedienungsanleitung

Mini-bar
Vorschau ausblenden Andere Handbücher für SMB 140 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Operation

Cooling beverages

You can set the minibar temperature to between
7°C (44°F) and 18°C (64°F).
TIPS
Depending on the room temperature, the ap-
pliance cools down by a maximum of 18°C
(33°F). The lowest attainable temperature
is 7°C (44°F). This means that, if you want
to cool beverages down to 7°C (44°F), the
room temperature may not be any higher
than 25°C (77°F).
The minibar should, therefore, be placed at a
location that is as cool as possible and that is
not warmed up by the sun.
Do not place it in the vicinity of heat-radiating
appliances such as heaters or stoves.
The appliance cannot be used for heating.
If the room temperature is cooler than the
adjusted temperature, the cooling system
switches itself off . The temperature then goes
up to no higher than the room temperature.
1) Insert the power plug into a mains power
socket.
Ensure that the power being supplied from the
mains power socket tallies with the voltage
specifi ed on the label.
The displays 4/5 show real-time tempera-
tures in the two zones.
NOTE
If you would like to change the units from
"°C" to "°F", press and hold the temperature
increase button 6 and the temperature
decrease button 7 simultaneously until the
temperature shown on the displays 4/5
changes.
If you are not sure which temperature unit is
currently being shown, change the display
again. The higher values express the tempera-
ture in degrees Fahrenheit (°F) and the lower
values express the temperature in degrees
centigrade (°C).
SMB 140 A1
2) Open the door 0.
3) Press the temperature increase button 2 or
the temperature decrease button 3 to set the
required temperature in the upper zone.
The display 4 fl ashes and shows the pro-
grammed temperature in the upper zone. If you
do not press any other buttons, fl ashing stops
and the display 4 once again shows the real-
time temperature in the upper zone.
Press the temperature increase button 6 or
the temperature decrease button 7 to set the
required temperature in the lower zone.
The display 5 fl ashes and shows the pro-
grammed temperature in the lower zone. If you
do not press any other buttons, fl ashing stops
and the display 5 once again shows the
real-time temperature in the lower zone.
The minibar now slowly cools down to the
programmed temperatures.
4) To switch off the minibar, you must unplug the
power plug from the mains power socket.

Illumination

If you wish, you can switch on a light in the inside
of the minibar.
There is separate lighting for the upper zone and
for the lower zone.
To switch on the light, press the corresponding light
button 1/8.
If you wish to switch the light off again, press the
corresponding light button 1/8 again.
ATTENTION! MATERIAL DAMAGE!
Since the LEDs in the interior of the minibar
have an extremely long service life, it is
neither necessary nor possible to replace
them. The LEDs are permanently set into
the light. Do not open the light under any
circumstances! This will irreparably damage
the appliance.
GB
IE
5

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ian 100658

Inhaltsverzeichnis