Safety Notices - Silvercrest SBB 850 A1 Bedienungsanleitung

Safety Notices

• Please read the operating instructions through completely before using the
appliance for the first time!
• Danger of suffocation! Children can suffocate through the improper use of
packaging materials. Dispose of them immediately after unpacking or store
them in a place that is out of reach of children.
• After unpacking, check the appliance for da-mage that may have occurred
during transportation. If necessary, contact your supplier.
• Place the appliance on a dry, flat and heat-resistant surface.
• Do not place the appliance near inflammable materials or explosive/ignitable
gases. A minimum distance of 10 cm must be maintained to all other materials.
• Ensure that the ventilation slots of the appliance are kept free at all times. Risk
of overheating!
• Before plugging the appliance in, check that the electricity type and mains
voltage matches the information given on the type plate.
• Do not place the power cable over sharp edges or close to hot surfaces or
objects. These may damage the insulation of the power cable.
• Never leave the appliance unsupervised whilst in use.
• To avoid the risk of tripping accidents the appliance is provided with a short
power cable.
• Only use the appliance inside buildings.
• Never place the appliance on or close to a gas or electric cooker, a hot
oven or any other source of heat. Risk of overheating!
• Never cover the appliance with a tea-towel or other material. Heat and
steam must be able to escape. A fire could occur if the appliance is covered
with an inflammable material or comes into contact with inflammable materials,
e.g. curtains.
• If you use an extension cable, ensure that the maximum permitted power rating
for the cable corresponds to that of the bread baking machine.
• Place the extension cable in such a way as to prevent anyone from tripping
over it or unintentially pulling on it .
• Always check the power cable and plug before use. Should the power cable
of the appliance become damaged, to avoid the risk of injury or a fatality it
must be replaced by the manufacturer, the manufacturer's customer service or
a similarly qualified specialist.
- 3 -