Clearaudio TT3 Bedienungsanleitung Seite 9

TT 3
User manual / Bedienungsanleitung
Therefore take one or more counterweight(s) (depending on the weight of your cartridge)
and slide them onto the headshell as shown in picture 12. Adjust little stylus pressure, while
sliding the counterweight(s) in the direction of the cartridge.
Pic.12: Setting up the counterweight(s)
Now lock the counterweight(s) by using the hex key wrench # 1.5.
It is easier, if the tonearm is in vertical position (as shown in picture 13).
Pic.13: Locking the counterweight(s)
4.2 VTA - adjustment
The following adjustment can be done with an old and used
record. This LP should be flat.
Instead of a record you can also use the delivered linear
tracking gauge.
Please unlock the screws on the side to change the height of
the tonearm. To achieve the right height of the cartridge you
can move the tonearm by turning the VTA screw on the top of
the tonearm
(shown in picture 14).
Pic.14: Height adjustment
Seite / Page 9  clearaudio electronic GmbH 2014