Tighten the screw of the tonearm base
as shown in picture 6.
For the next step please remove first all counterweights from
the headshell.
Slide the headshell through the proper drilling in the
carriage of the tonearm.
When sliding the headshell, turn the headshell
(as shown in pic. 8) so that the positioning shaft of the
headshell can pass the main rod of the tonearm.
After passing the first main rod, turn the headshell back (as
shown in pic. 9)
Pic.8: Turning the headshell
Seite / Page 7
Positioning shaft
Pic.10: Correct position of the headshell
TT 3
User manual / Bedienungsanleitung
Pic.6: Tighten the VTA-assembly
Pic.8: To seize the screw
Pic.7: Setting up the headshell
Pic.9: Turning the headshell back
clearaudio electronic GmbH 2014