Ensure that the work area is well ventilated and that there are
■
no open fl ames or other ignition sources in the vicinity. Other-
wise, there is risk of explosion!
Do not pump water, the oil suction pump will not be suffi -
■
ciently lubricated and could overheat.
The device is not suitable for the storage and/or transport of
■
fuels or other liquids.
Do not pump diff erent oils into the same tank.
■
Be extra careful when operating the oil suction pump and do
■
not leave it unattended when it is in operation.
Use the oil suction pump only when the engine oil is warm.
■
Hot oil can melt the hose.
The oil suction pump must NEVER be operated without the
■
suction hose, otherwise the pump motor could be overloaded.
To avoid overheating or malfunctions, the oil suction pump
■
should never be operated continuously for longer than
30 minutes. Allow the oil suction pump to cool down for ap-
prox. 10 minutes.
Use only the supplied connection terminals to connect the
■
device to a car battery.
Keep the connection cable away from hot parts of the en-
■
gine and do not let it hang over sharp edges.
Route the connection cable so that it cannot be caught up in
■
moving parts of the engine.
Disconnect the connection cable from the car battery when
■
the device will not be in use for longer periods of time.
Keep sources of ignition (e.g. naked fl ames, lighted cigars,
■
cigarettes or electrical sparks) away from the car battery.
There is the risk of an explosion!
Avoid causing an electrical short-circuit when connecting
■
the device to the battery. Connect the positive pole terminal
clamp only to the positive pole of the battery. Connect the
negative pole terminal clamp only to the negative pole of
the battery.
Connect the terminal clamps ("–" and "+") only to the insu-
■
lated area!
UOP 12 A1
GB
IE
5