What To Do If; Possible Cause - Electrolux EOB3410 Benutzerhandbuch

Installing the door and the glass panel

10. WHAT TO DO IF...

WARNING!
Refer to "Safety information"
chapter.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The oven lamp does not
operate.
The display shows 12.00. There was a power cut.
Steam and condensation
settle on the food and in
the oven.
If you cannot find a solution to the prob-
lem yourself, contact your dealer or the
service centre.
We recommend that you write the data here:
Model (MOD.)
Problem
When the cleaning is completed, install
the glass panels and the oven door. Do
the above steps in the opposite se-
quence.
Make sure that you put the glass panels
back in the correct sequence. The second
panel has a decorative frame. The screen-
printing zone must face the inner side of
the door. Make sure that after the installa-
tion the surface of the glass panel frame
on the screen-printing zones is not rough
when you touch it.
Make sure that you install the middle pan-
el of glass in the seats correctly (refer to
the illustration).

Possible cause

The appliance is deacti-
vated.
The clock is not set.
The necessary settings
are not set.
The fuse in the fuse box
is released.
The oven lamp is defec-
tive.
You left the dish in the
oven for too long.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the appliance cavity.
Remedy
Activate the appliance.
Set the clock.
Make sure that the set-
tings are correct.
Do a check of the fuse. If
the fuse is released more
than one time, contact a
qualified electrician.
Replace the oven lamp.
Set the clock.
Do not keep the dishes in
the oven for longer than
15 - 20 minutes after the
cooking ends.
.........................................
ENGLISH 21