Electrolux EHH9967FOG Benutzerhandbuch Seite 15

Problem
There is no signal when
you touch the panel sen-
sor fields.
comes on.
comes on.
comes on.
and a number come
on.
comes on.
comes on.
Possible
The signals are deactiva-
ted.
The Automatic Switch Off
operates.
The Child Safety Device
or the Lock function op-
erates.
No cookware is on the
cooking zone.
The cookware is incor-
rect.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone.
The cookware does not
cover the square.
There is an error in the
appliance.
The electrical connection
is incorrect. The supply
voltage is out of range.
There is an error in the
appliance because a
cookware boils dry. The
overheating protection for
the cooking zones and
the Automatic Switch Off
operate.
ENGLISH
Remedy
Activate the signals (refer
to "OffSound control").
Deactivate the appliance
and activate it again.
Refer to the chapter "Dai-
ly Use".
Put cookware on the
cooking zone.
Use correct cookware.
Use cookware with cor-
rect dimensions.
Cover the square fully.
Disconnect the appliance
from the electrical supply
for some time. Discon-
nect the fuse from the
electrical system of the
house. Connect it again.
If comes on again,
speak to the service cen-
tre.
Speak to a qualified elec-
trician to check the instal-
lation.
Deactivate the appliance.
Remove the hot cook-
ware. After approximately
30 seconds, activate the
cooking zone again. If the
cookware was the prob-
lem, the error message
goes out of the display,
but the residual heat indi-
cator can stay. Let the
cookware become suffi-
ciently cool and refer to
"Cookware for the induc-
tion cooking zone" to see
if your cookware is com-
patible with the appli-
ance.
15