Wiring Connection - Kenwood KDC-BT510U Bedienungsanleitung

INSTALLATION/CONNECTION

Wiring connection

Rear/Subwoofer output
For 3-way crossover:
Woofer output
Connecting the ISO connectors on some VW/Audi or Opel
(Vauxhall) automobiles
You may need to modify the wiring of the supplied wiring harness as
illustrated below.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
Pin Color and function (for ISO connectors)
: Battery
A4 Yellow
A5 Blue/White : Power control
: Ignition (ACC)
A7 Red
: Earth (ground) connection
A8 Black
Purple ]
B1
: Rear speaker (right)
For 3-way crossover: Tweeter (right)
Purple/black [
B2
Gray ]
B3
: Front speaker (right)
For 3-way crossover: Mid range speaker (right)
B4 Gray/black [
White ]
B5
: Front speaker (left)
For 3-way crossover: Mid range speaker (left)
White/black [
B6
Green ]
B7
: Rear speaker (left)
For 3-way crossover: Tweeter (left)
Green/black [
B8
Microphone input jack ( 10)
Antenna terminal
Ignition wire (Red)
Unit
Battery wire (Yellow)
Fuse (10 A)
If no connections are made, do not let the wire come out from
Yellow (Battery wire)
the tab.
Light blue/yellow
Red (Ignition wire)
(Steering remote
control wire)
Red (A7)
Blue/White
(Power control wire/
Antenna control wire)
Yellow (A4)
Brown
(Mute control wire)
ISO connectors
If your car does not have an ISO terminal:
We recommend installing the unit with a commercially
available custom wiring harness specific for your car and leave
this job to professionals for your safety. Consult your car audio
dealer.
When connecting to an external amplifier, connect its ground
wire to the car's chassis to avoid damaging the unit.
STEERING WHEEL
REMOTE INPUT
To the steering wheel remote control
REMOTE CONT
adapter
To the power control terminal when
ANT CONT
using the optional power amplifier
P. CONT
or to the antenna control terminal in
the vehicle
To connect the Kenwood navigation
system, refer your navigation
MUTE
manual
27
ENGLISH