Siemens TE506 Serie Gebrauchsanleitung Seite 43

Simple troubleshooting
Problem
Water dripped onto the in­
ner floor of the appliance
when the drip tray (8) was
removed.
Display shows
Insert brewing unit
Restore the unit to its
original factory settings
("Reset").
If you are unable to solve the problem, please call the hotline.
You will find the telephone numbers at the back of these instructions.
TE506_1DE.indb 43
Cause
Drip tray (8) removed too
early.
Brewing unit (5) is missing
or was not recognised.
You changed some settings
and want to discard them.
Solution
Wait a few seconds after
the last drink was dispensed
before removing the drip
tray (8).
Switch off the appliance with
the brewing unit (5) in place,
wait three seconds and
switch on the appliance.
Turn off the unit with
the power on/off switch
O / I (9). Press and hold
e
j
the off / (13) and the
h
(12) button and turn
the appliance on with the
power on/off switch O / I (9).
Confirm by pressing the
start button start (10).
The factory settings are now
activated.
20.06.2012 11:58:03
en de
43