Descaling - Siemens TE506 Serie Gebrauchsanleitung

Never interrupt the service programme!
Do not drink the liquids!
Never use vinegar, vinegar­based products,
citric acid or citric acid­based products!
Never put descaling tablets or other descal­
ing agents in the ground coffee drawer or
the drawer for cleaning tablets (4)!
Specially developed descaling and
cleaning tablets are available from
retailers or customer service.
Order number
Cleaning
tablets

Descaling

tablets
Descaling
Duration: approx. 25 minutes.
Important: If there is a filter in the water
tank (17), it needs to be removed before the
descaling programme is run.
Descale required!
If the message
pears on the display, press the
button (13) for 3 seconds and then press
the start button (10). The descaling pro­
gramme will start. To descale the appliance
before being prompted, press the
j
button (13) for at least 3 seconds. Then
e
press the off /
Turn the upper rotary knob (15) until
descaling
appears in the display. To start
the descaling procedure, press the start
button (10).
The display will guide you through the
programme.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
N.B.: If the water filter is activated, the
display will prompt you to remove the filter
and then press the start button (10) again.
TE506_1DE.indb 37
Retail Customer
service
TZ60001 310575
TZ60002 310967
ap­
e
j
off /
e
off /
j
button (13) briefly twice.
Start
Remove the filter now if you have not al­
ready done so. Press the start button (10).
Fill descaler
Press start
● Pour lukewarm water into the empty wa­
ter tank (17) up to the 0,5l mark and dis­
solve 2 Siemens descaling tablets in it.
● Press the start button (10).
Place container
Press start
● Place a receptacle with a capacity of at
least 0.5 litres under the outlet (6a).
● Press the start button (10).
Descale in progress
The descaling pro gramme will now run for
about 20 minutes.
Clean / Fill water tank
Press start
● Rinse the water tank (17) and refill it with
fresh water up to the max mark.
● Press the start button (10).
Descale in progress
The descaling pro gramme now runs for
about 3 minutes and rinses the appliance.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
Replace the filter if one is being used. The
appliance has completed descaling and is
ready for use again.
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion. New sponge cloths may
contain salts. Salts can cause rust film
on stainless steel and must therefore be
washed out thoroughly before use.
de en
37
20.06.2012 11:58:03