Frost Protection; Accessories - Siemens TE506 Serie Gebrauchsanleitung

Fill descaler
Press start
● Pour lukewarm water into the empty wa­
ter tank (17) up to the 0,5l mark and dis­
solve 2 Siemens descaling tablets in it.
● Press the start button (10).
Place container
Press start
● Place a receptacle with a capacity of at
least 1 litre under the outlet (6a).
● Press the start button (10).
Calc'n'Clean in progress
The descaling pro gramme will now run for
about 22 minutes.
Clean / Fill water tank
Press start
● Rinse the water tank (17) and refill it with
fresh water up to the max mark.
● Press the start button (10).
Calc'n'Clean in progress
The descaling pro gramme now runs for
about 10 minutes and rinses the appliance.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
Replace the filter if one is being used. The
appliance has finished cleaning is ready for
use again.
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion. New sponge cloths may
contain salts. Salts can cause rust film
on stainless steel and must therefore be
washed out thoroughly before use.
TE506_1DE.indb 39

Frost protection

¡
To avoid damage from low tempera­
tures during transport and storage,
the appliance must be completely
emptied first.
Note: The appliance must be ready for use
and the water tank (17) filled.
1. Place a large receptacle under
outlet (6a).
h g
2. Press the / button (12) and allow
the appliance to steam for about 15
seconds.
3. Switch the appliance off at the power
on/off switch O / I (9).
4. Empty the water tank (17) and the drip
tray (8).

Accessories

The following accessories can be obtained
from retailers and customer service.
Order Retail
number
Cleaning TZ60001
tablets
Descaling TZ60002
tablets
Water filters TZ70003
Milk container TZ70009
(insulated)
de en
Customer
service
310575
310967
467873
673480
39
20.06.2012 11:58:03