Plug Socket; Electrical Connection - AEG S41600TSW1 Benutzerhandbuch

1
1
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly
to the cabinet. In that case, wait for the
natural fitting of the gasket.

9.8 Plug socket

9.9 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
2
2
• Remove the door by pulling it down-
wards while keeping it slightly
opened.
• Unscrew the upper door hinge, and
screw it in on the opposite side.
• Put the door back in its place.
• Relocate the door holder pin in the
door hinge as per the figure.
• Place the door holder pin in the door
at the bottom on the left side, and fix
the door hinge with the screw.
• Screw the right foot.
• Raise the appliance in the upright po-
sition.
• Remove and install the handle (if fore-
seen) on the opposite side.
• Reposition, level the appliance, wait
for at least four hours and then con-
nect it to the power socket.
In case you do not want to carry out the
above mentioned operations, contact
the nearest After Sales Service Force.
The After Sales Service specialist will car-
ry out the reversibility of the doors at
your cost.
CAUTION!
Make sure that the mains cable
can move freely.
The plug socket necessary for connec-
tion of your appliance to the electricity
supply should be positioned so that it is
possible to pull out the appliance plug.
If your appliance is installed under a con-
tinuous worktop, the plug socket should
be provided as shown.
plate correspond to your domestic pow-
er supply.
The appliance must be earthed. The
power supply cable plug is provided
ENGLISH
15