Plug Socket; Electrical Connection - AEG S71700TSX0 Benutzerinformation

16
Installation
12. Remove and install the handle
opposite side.
13. Reposition, level the appliance, wait for
at least four hours and then connect it
to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natu-
ral fitting of the gasket.
In case you do not want to carry out the above mentioned operations, contact the near-
est After Sales Service Force. The After Sales Service specialist will carry out the reversibil-
ity of the doors at your cost.

Plug socket

CAUTION!
Make sure that the mains cable can move freely.
The plug socket necessary for connection of your
appliance to the electricity supply should be posi-
tioned so that it is possible to pull out the appli-
ance plug.
If your appliance is installed under a continuous
worktop, the plug socket should be provided as
shown.

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the rating plate cor-
respond to your domestic power supply.
The appliance must be earthed. The power supply cable plug is provided with a contact
for this purpose. If the domestic power supply socket is not earthed, connect the appli-
ance to a separate earth in compliance with current regulations, consulting a qualified
electrician.
The manufacturer declines all responsibility if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Directives.
4) If foreseen
4)
on the