Turning The Burner Off - AEG HG755520 Benutzerinformation

22 www.aeg.com
Always light the burner before
you put cookware.
To light the burner:
1. Turn the control knob counterclock-
wise to the maximum position (
) and push it down.
2. Keep the control knob pushed for
approximately 5 seconds; this will let
thermocouple to warm up. If not, the
gas supply will be interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner
does not light, check if the crown
and its cap are in correct posi-
tions.
A) Burner cap and crown
B) Thermocouple
C) Ignition candle
A) Burner cap
B) Burner crown
C) Ignition candle
D) Thermocouple
A
WARNING!
Do not keep the control knob
pushed for more than 15 sec-
onds.
If the burner does not light after
15 seconds, release the control
B
knob, turn it into off position and
try to light the burner again after
minimum 1 minute.
C
In the absence of electricity you
can ignite the burner without
electrical device; in this case ap-
proach the burner with a flame,
push the relevant knob down
and turn it counter-clockwise to
maximum gas release position.
If the burner accidentally goes
out, turn the control knob to the
off position and try to light the
burner again after minimum 1 mi-
nute.
The spark generator can start au-
tomatically when you switch on
the mains, after installation or a
power cut. It is normal.

4.2 Turning the burner off

To put the flame out, turn the knob to
the symbol .
A
B
C
D