Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2
Installation
Refer to the nearest Authorized Service Agent for
installation of the product. To make the product
ready for use, make sure that the electricity and
water drainage system are appropriate before
calling the Authorized Service Agent. If they are
not, call a qualified technician and plumber to have
any necessary arrangements carried out.
C
Preparation of the product's location as well
as the electrical and waste water installations
is under customer's responsibility.
B
Installation and electrical connections of the
product must be carried out by the Authorized
Service Agent. Manufacturer shall not be
held liable for damages that may arise from
procedures carried out by unauthorized
persons.
A
Prior to installation, visually check if the
product has any defects on it. If so, do not
have it installed. Damaged products cause
risks for your safety.
A
Let your dryer wait for 12 hours before
starting to use it.
Appropriate installation location
•
Install the product on a stable and level
surface.
•
Dryer is heavy. Do not move it by yourself.
•
Operate your product in a well ventilated,
dust-free environment.
•
Do not block the air ducts in front of and
under the product with materials such as long
pile rugs, wooden blocks and bands.
•
Do not install the product behind a door with
a lock, sliding door or a hinged door which
can strike the product.
•
Once the product is installed, it should stay at
the same place where its connections have
been made. When installing the product,
make sure that the rear wall of it does not
touch anywhere (tap, socket, etc.). Also pay
attention to select an installation location
which you will not be required to change
afterwards.
•
Place the product at least 1.5 cm away from
the edges of other furniture.
B
Do not place the product on the power cable.
Removing the transportation safety
assembly
A
Remove the transportation safety assembly
before using the product for the first time.
1. Open the loading door.
2. There is a nylon bag inside the drum that
contains a piece of styrofoam. Hold it from its
section marked with XX XX.
3. Pull the nylon towards yourself and remove
the transportation safety assembly.
A
Make sure that no part of the transportation
safety assembly remains inside the drum.
Under counter installation
•
This product can be installed under a counter
if the height of the counter is sufficient.
A
While using undercounter dryer, it should
never be operated without undercounter
installation part.
Dryer Depth
Stock number
of under-bench
installation part
•
Leave at least 3 cm of space around the
sides and the rear wall of the product when
installing it under a counter or in a cupboard.
32 EN
60 cm
54 cm
2979700100
2973600100
Werbung
Inhaltsverzeichnis
