IKEA GRILJERA 80316982 Bedienungsanleitung Seite 9

ENGLISH
LED light
The hood is equipped with a lighting system
based on LED technology.
The LEDs guarantee an optimum lighting,
a duration up to 10 times as long as the
What to do if ...
Problem
The appliance does not work
The hood's suction level is not
enough
The light does not work
Before contacting the Authorized Service
Centre:
Switch the appliance on again to see if the
problem has disappeared. If not, switch it
off again and repeat the operation after an
hour.
If your appliance still does not work properly
after carrying out the checks listed in the
troubleshooting guide and switching the
appliance on again, contact the Authorized
Service Centre, clearly explaining the
problem and specifying:
traditional lamps and allow to save 90%
electrical energy.
For replacement, contact the Authorized
Service Centre.
Possible cause
There is no mains
electrical power
The appliance is not
connected to the
electrical supply
The suction speed is too
low
The metal filters are
dirty
The air vents are
obstructed
The LED is broken
• the type of fault;
• the model;
• the type and serial number of the
appliance (given on the rating plate);
• the Service number (the number after the
word SERVICE on the rating plate inside the
appliance).
Solution
Check for the presence of
mains electrical power.
Turn off the appliance and
restart it to see if the faults
persists.
Check if the appliance is
connected to the electrical
supply.
Turn off the appliance and
restart it to see if the faults
persists.
Check the suction speed and
adjust as necessary.
Check that the filters are clean
If not, clean the filters in the
dishwasher.
Check the air vents for any
obstructions and remove as
necessary.
For replacement, contact the
Authorized Service Centre.
9