Initial Installation - Xoro HRS 8588 Bedienungsanleitung

Initial Installation

The XORO installation menu will be displayed by initial operation of the HRS8588. This menu con-
tains four options:
1. OSD Language
2. Country
3. Channel search
4. Load the pre-inst.
Navigate with the arrow keys CH+ and CH– to high
light the option and make the selection with the VOL–
and VOL+ buttons.
OSD Language
Choose the menu language.
Country
Select the country where you use the HRS8588
Channel Search
Please select "Channel Search/Satellite Setting" to define further parameters for a scanning, if your
satellite receiving system fulfill following criteria:
System with rotatable antenna
System with more than one antenna or LNB (DiSEqC)
System with nonstandard components
Most of the customers could complete the installation by selecting "load the pre-inst.".
Load the Pre-inst.
A program list of the satellite ASTRA 19.2° is saved in
the factory firmware. German TV programs top this list.
In most cases, the installation is completed with loading
the program list.
Select the OSD language and country and decide
whether to load the pre installed program list.
Press OK to confirm.
The first TV program will be shown on the
screen after loading the pre programmed list. If
there is no TV program to be seen, please
check the cable connection, Antenna Set up
and carry out the channel scanning.
If you have chosen not to take the pre installed list, there appears a "Dish Setup" menu on
the screen.
For the case there appears no "Installation Guide" menu after connection and power on, please read
the page 35 to reset the device.
16
Initial Installation
HRS 8588