Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
This device falls under protection-class I. The power plug must only be plugged into a protection class I
outlet.
Always plug in the power plug last.
Never let the power-cord come into contact with other cables! Handle the power-cord and all connections
with the mains with particular caution!
Make sure that the available voltage is not higher than stated on the rear panel.
Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and the
power-cord from time to time.
Never drink fluid or use it on the inside or outside of a human body. If fluid gets in contact with skin or eyes,
rinse thoroughly with water. If it is necessary call a doctor immediately!
DANGER TO LIFE!
- Danger of suffocation for people or animals lying under the foam.
- Maintain sufficient sight in all directions.
- When operating the device, a sufficient number of safety personell has to be present for supervising the
foam area so that any „disappearing" person will immediately be noticed. If in doubt, the safety personell has
to limit the number of persons in the foam. The safety personell must also verify that only such persons are
allowed into the foam who are fully clear.
- After switching off the foam machine, the safety personell must remain in the foam area, until the foam has
completely disintegrated.
- There must be no obstacles in the foam area.
- The floor surface must be sufficiently anti-slippery. After the foam has disintegrated, the safety personell
must verify that the floor surface is completely dry and not slippery.
Keep device upright.
For overhead use (mounting height >100 cm), always fix the fixture with an appropriate safety bond.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power-cord by the plug. Never pull out the plug by tugging the power-cord.
Unused machines must be disconnected from the mains. If the power plug or the power switch is not
accessible, the device must be disconnected via the mains.
Keep away children and amateurs!
Never leave this device running unattended.
OPERATING DETERMINATIONS
This device is a special effect machine for creating foam effects. This product is only allowed to be operated
with an alternating voltage of 230 V, 50 Hz and was designed for indoor use only.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. Please consider that liquid may be spilt during operation around the device. The resulting
slippery surface can cause accidents. There should not be any cables lying around. You endanger your own
and the safety of others!
13/32
00043721.DOC, Version 1.1
Werbung
Inhaltsverzeichnis
