What To Do If - AEG 68456VS-MN Benutzerinformation

32 www.aeg.com
Inserting the drawer
1. Set the drawer on the support rails.
Make sure that the catches engage
correctly into the rails.
2. Lower the drawer until it is horizontal
and push it in.

12. WHAT TO DO IF...

WARNING!
Refer to the Safety chapters.
The residual heat indica-
tor does not come on
The appliance does not
operate.
The appliance does not
operate.
The appliance does not
operate.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The oven lamp does not
operate.
The Pyro Cleaning does
not start. The display
shows C1.
The Pyro Cleaning does
not start. The display
shows C3.
Problem Possible cause
The cooking zone is not
hot because it operated
only for a short time
The power plug is not
correctly put in.
The earth fault switch is
switched off.
The appliance is off.
The appliance is deacti-
vated.
The clock is not set.
The necessary settings
are not set.
The automatic switch-off
is on.
The Child Lock is on.
The fuse in the fuse box
is released.
The oven lamp is defec-
tive.
The shelf supports are
not removed.
The door is not fully
closed or the door lock is
defective.
WARNING!
When the oven is in use, heat can
build up in the drawer. Do not
keep flammable things in there
(e.g. cleaning materials, plastic
bags, oven gloves, paper, clean-
ing sprays, etc.).
Solution
If the cooking zone must
be hot, speak to the af-
ter sales service
Put in the power plug
correctly.
Switch on the earth fault
switch.
Switch on the appliance.
Activate the appliance.
Set the clock. Refer to
"Setting the time of
day".
Make sure that the set-
tings are correct.
Refer to "Automatic
switch-off".
Refer to "Deactivating
the Child Lock".
Do a check of the fuse. If
the fuse is released more
than one time, contact a
qualified electrician.
Replace the oven lamp.
Remove the shelf sup-
ports.
Fully close the door.