Dmx-Controlled Operation; Addressing; Dmx-Protocol - EuroLite LED TMH-21.i Twin Bedienungsanleitung

DMX-controlled operation

You can control the projectors individually via your DMX-controller.
Every DMX-channel has a different occupation with different features. The individual channels and their
features are listed under DMX-protocol.

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH-21.i Twin will respond to the controller.
If you set, for example, the address in the 24 channel mode to channel 25, the device will use the channel 25
to 48 for control.
Please, be sure that you don't have any overlapping channels in order to control each LED TMH-21.i Twin
correctly and independently from any other fixture on the DMX-chain.
If several LED TMH-21.i Twin are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED
TMH-21.i Twin via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the display will show "A.001" with the actually set address, the dot will flash. If there is no data
received at the DMX-input, the display will show "A001" with the actually set address.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.

DMX-protocol

Mode/Channel Decimal Hexad. Percentage S/F
17 CH 24 CH
1 1
0 255 00 FF
2 2
0 255 00 FF
3 3
0 255 00 FF
4 4
0 255 00 FF
5 5
0 255 00 FF
6 6
0 255 00 FF
Horizontal movement (PAN)
Push slider up in order to move the head horizontally
(PAN). Gradual head adjustment from one end of the
0% 100% F
slider to the other (0-255, 128-center). The head can be
stopped at any position you wish.
PAN-movement with 16-bit resolution
0% 100% F Fine indexing
Vertical movement (TILT1)
Push slider up in order to move the head vertically
(TILT). Gradual head adjustment from one end of the
0% 100% F
slider to the other (0-255, 128-center). The head can be
stopped at any position you wish.
TILT1-movement with 16-bit resolution
0% 100% F Fine indexing
Vertical movement (TILT2)
Push slider up in order to move the head vertically
(TILT). Gradual head adjustment from one end of the
0% 100% F
slider to the other (0-255, 128-center). The head can be
stopped at any position you wish.
TILT2-movement with 16-bit resolution
0% 100% F Fine indexing
26/31
Feature
00092157, Version 1.2