Setting Up; Headset Port; Default Outbound Call Mode; Connecting To The Gn1000 Rhl (Remote Handset Lifter) (Gn Accessory) - Jabra GN9330e USB Anleitung

2. Setting up

This section contains set-up and connection instructions for your headset's accessories and
optional functions.
Note: Your Guide for basic set-up and use contains the primary set-up and connection instructions.
GN9350e GN9330e GN9330e USB
2.1 H eadset port
If your telephone has a port for headset, it is recommended to leave the handset cord in the
telephone. Connect the telephone's headset port to the telephone port on the base. This will
enable you to use the call button on your telephone, if there is one, and will limit the number
of cords coming out of your base.
GN9350e GN9330e GN9330e USB
2.2 D efault Outbound Call mode
The base is default set for telephone use. If you want to use your VoIP application as default
calling media, press the USB button for 5 seconds. If you want to change it back again,
press the Telephone button for 5 seconds
GN9350e GN9330e GN9330e USB
2.3 C onnecting to the GN1000 RHL (Remote Handset Lifter)
(GN accessory)
You may purchase a GN1000 RHL as an accessory, which lets you answer and end telephone
calls while away from your desk. Please contact your vendor or visit
www.jabra.com for further details.
To connect your GN1000:
1. Mount the GN1000 to your telephone as described in its
user manual.
2. Plug RHL's connection cord into headset base's AUX port.
The GN9350e enables you to use electronic hookswitch
(EHS) to answer and end calls while away from your desk.
Feature is described in section 2.5.2.
The remote answering and ending of calls is also available on
certain softphone/VoIP applications.
4
GN9350e GN9330e GN9330e USB
2.4 Connecting to external Online Indicator (OLI) (GN accessory)
An external online indicator (accessory) can be placed on your desk or near your telephone to
indicate when you're on a call.
To connect to an external OLI: Plug cord from OLI to base's OLI port.
GN9350e GN9330e GN9330e USB
2.5 LCD display
Your base unit has a LCD display and display control with which you control 5 settings:
Transmit volume setting
Hookswitch selection
Range/power selection
Sound mode selection
®
Protection level selection (IntelliTone
Navigation and markers
Navigate through the LCD display's 5 menus horizontally using the display control's
rows. Within each of the 5 menus, navigate vertically with the display control's
Press the OK button to confirm a specific choice/value within the 5 different menus. A star (*)
beside a selected choice/value indicates the current setting.
Default/start position
The LCD display is always on and ready to use. The permanent default/start position for the
LCD display is the leftmost transmit volume setting
this default/start position, if not operated for 30 seconds.
Within each of the 5 menus, there is also a factory-set default. This default remains until you
change it. The last selected choice/value (within each of the 5 menus) is always displayed in
the first line of its menu.
Changing the settings
2.5.1 Transmit volume
The transmit volume must be adjusted properly so your voice is heard clearly.
If you haven't already adjusted the transmit volume during your initial setting up, do so now
by completing the following:
1. Put on headset.
2. Use 3 4 to locate transmit volume menu
)
34
5 6
arrows.
. The LCD display will always revert to
on base display.
5
ar-